Roller Shutter Door Spares and Replacement Parts in Alberton

Roller shutter door spares in Alberton are almost always needed at short notice, and the difference between a door back in service today and a door out for a fortnight is whether the part is held locally. We stock the parts our own doors use and the common sizes for the makes that keep turning up on Alrode and southern Ekurhuleni sites.

Roller shutter door spares we supply in Alberton

• Slats and curtain sections in the common galvanised and aluminium profiles.
• Guides and guide inserts, including deeper sections for impact-prone bays.
• Springs, shafts and barrel components matched to span and door mass.
• Tube and side motors, gearboxes and manual overrides.
• Bottom rails, locks and end locks.
• Safety edges, photocells, control panels and remotes.

Corrosion-resistant hardware for industrial sites

On plants around Alrode the parts that fail first are the small ones: end locks, fixings, bottom rails and bearings. Replacing them like for like puts you back on the same failure. We supply heavier-coated and stainless alternatives where the atmosphere justifies it, and we will tell you which items are worth the upgrade and which are not.

Garage door spares

We carry torsion and extension springs, cables, drums, rollers, hinges, brackets and operator parts for sectional and roll-up garage doors, which covers most of the residential work through Alberton North, Raceview, Randhart, Brackenhurst, Brackendowns and Meyersdal.

Identifying the right part

Most wrong parts get ordered from a description. Send photographs of the fault, the barrel end, the guide section and any plate on the motor, plus the opening width. From that we can usually identify the part without a site visit, and we would rather ask for one more photo than send you the wrong item.

Parts for older and obsolete doors

Doors on the older Alrode industrial stock are frequently out of production. We fabricate or adapt where the profile no longer exists, and we say plainly when adapting is a short-term repair rather than a proper fix.

Supply only or supply and fit

We sell parts across the counter to plant maintenance teams and contractors who do their own work, and we fit them where you would rather the job was warranted end to end. Tension component work is worth having done by someone with the correct tools, because a wound torsion assembly is a real hazard.

Consumables worth holding on site

Plants that run doors hard keep a small stock of end locks, bottom-rail seals, photocell pairs and a spare drive. On a continuous operation that is very little money against the cost of a bay standing.

Ordering roller shutter door spares in Alberton

Send photos and the opening size. We confirm the part, the price and whether it is in stock, on order or has to be made before you commit.